Flash-To-Pass; Windshield Wipers - Chevrolet 2009 Corvette Owner's Manual

Flash-to-Pass

To use the flash-to-pass feature, briefly pull the turn
signal lever toward you. The high-beam indicator flashes
to indicate to the other driver that you intend to pass.
If the low-beam headlamps are off and the fog lamps are
on, the fog lamps flash.

Windshield Wipers

The windshield wiper lever is located on the right side of
the steering column.
Move the lever to the following positions:
1 (High Speed): For steady wiping at high speed.
6 (Low Speed): For steady wiping at low speed.
& (Delay): Use to set a delay between wipes.
x (Delay Adjustment): Use for a delayed wiping
cycle. Turn the intermittent adjust band down for
a longer delay or up for a shorter delay. The wiper
speed can only be manually adjusted when the lever
is in this position.
9 (Off): Turns off the windshield wipers.
8 (Mist): Move all the way down to mist and release
for a single wiping cycle. The windshield wipers will
stop after one wipe. Hold the band on mist longer for
more wipes.
Heavy snow or ice can overload the wipers. If this
occurs, a circuit breaker will stop the wipers until the
motor cools. Clear all ice and snow from the windshield
wiper blades before using them. If the wiper blades
are frozen to the windshield, carefully loosen them or
warm the windshield before turning the wipers on. If they
become worn or damaged, get new blades or blade
inserts.
3-9