Mowing Height Adjustment; Foot Pedal Adjustment; Floor Pan Removal & Installation - Ferris IS2000Z Series Operator's Manual

WARNING
DO NOT adjust the tractor for a faster overall speed
forward or reverse than it was designed for.

Mowing Height Adjustment

The cutting height adjustment pin (A, Figure 38) controls the
mower cutting height. The cutting height is adjustable between
1-3/4" (4,4 cm) and 5" (12,7 cm) in 1/4" (0,64 cm) increments.
38
1. Depress the deck lift foot pedal (B) until it locks into the 5"
(12,7 cm) position.
2. Place the cutting height adjustment pin in the desired cutting
height.
3. Depress the deck lift foot pedal then push the lock lever (C)
towards the right to release the lock.
4. Release the deck lift foot pedal until it comes to rest against
the cutting height adjustment pin.

Foot Pedal Adjustment

The deck lift foot pedal can be adjusted to accommodate the
operator's height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 39) from the pedal mount
tab (B).
28
39
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the proper
orientation as shown in Figure 39.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1. Loosen and remove the knob (A, Figure 40) that secures
the floor pan to the frame of the unit.
40
2. Tilt the back end of the floor pan up and then remove it from
the unit.
3. To re-install the floor pan: Reverse the removal procedure.
ferrisindustries.com