Ferris IS2000Z Series Operator's Manual page 13

G Fuel Tank Cap
H Fuel Level Guage
I Retractable Seat Belt
J Removable Floor Plate (S/N: 2016269736 & Above)
Deck Lift Pedal, Cutting Height Adjustment Pin & Deck Lift
Lock Lever: These control the cutting height of the mower deck.
Depress the pedal until it locks into the 5" (12,7 cm) position.
Place the adjustment pin in the desired cutting height and release
the lift lock lever.
Cutting Height Adjustment Pin
Deck Lift Lock Lever
Parking Brake: Pull the parking brake lever back to engage
the parking brake. Move the lever fully forward to disengage the
parking brake. NOTE: To start the unit the parking brake must
be engaged.
Icon Name Description
Disengage Releases the parking brake.
Engage Locks the parking brake.
Seat Adjustment Lever: The seat can be adjusted forward and
back. Move the lever towards the left, position the seat as
desired, and release the lever to lock the seat in position.
Ground Speed Control Levers: These levers control the ground
speed of the rider. The left lever controls the left rear drive wheel
and the right lever controls the right rear drive wheel.
FORWARD
NEUTRAL
REVERSE
Moving a lever forward increases the FORWARD speed of the
associated wheel, and pulling back on a lever increases the
REVERSE speed.
Note: The further a lever is moved away from the neutral position
the faster the drive wheel will turn.
See the Zero-Turn Driving Practice section for steering
instructions.
Fuel Tank Cap: To remove the cap, turn counterclockwise.
Fuel Level Gauge: Displays the fuel level in the tank.
Retractable Seat Belt: The seat belt is used to secure the
operator to the seat.
The seat belt should always be worn when the Roll Bar is in the
raised position. The seat belt should never be worn when the
Roll Bar is in the down position.
Removable Floor Plate: The floor plate can be removed for
easy access to the mower deck. To remove the plate, remove
the black knob and tilt the floor pan up and then remove from
the machine. Reverse process for re-installation.
Instrument Control Panel
5
Callout Control Name
A Choke
B PTO Switch
C Ignition Switch
D Throttle Control
E Hour Meter
F Fuel Selector Valve
G Fuse Block
Choke: Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not require choking.
Pull the knob UP to close the choke. Push to knob DOWN to
open the choke.
PTO (Power Take Off) Switch: The PTO switch engages
and disengages the mower. Pull UP on the switch to engage,
and push DOWN to disengage.
13