Entering And Exiting The Adjustment Process Mode; Description Of Display - Sharp LC-32X20E Service Manual

LC-32X20E/S/RU, LC-37X20E/S/RU

2. Entering and exiting the adjustment process mode

1. Press the "POWER" key on the set of running TV set to force off the power.
2. While holding down the "VOL (-)" and "INPUT" keys on the set at once, plug in the AC power cord to turn on the power.
The letter "K" appears on the screen.
3. Next, hold down the "VOL (-)" and "P (V)" keys on the set at once.
Multiple lines of character string appearing on the screen indicate that the set is now in the adjustment Process mode. If you fail to enter the
adjustment process mode (the display is the same as normal startup), retry the procedure. (Another procedure)
4. Press the "MENU" key on the main unit to display OSD.
5. Move the cursor to SERVICE (OSD) using the cursor keys on the remote control.
Then press the "MENU" key on the remote control to enter the service mode (adjustment process mode).
6. To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off the power. (When the power is turned off
with the remote controller, once unplug the AC power cord and plug it in again. In this case, wait 10 seconds or so before plugging.)
CAUTION: Use due care in handling the information described here lest the users should know how to enter the adjustment process mode. If the
settings are tampered with in this mode, unrecoverable system damage may result.
3. Remote controller key operation and description of display in adjustment process mode.
1. key operation
Remote controller key
P ( / )
VOL (+/-)
Cursor (UP/DOWN)
Cursor (</>)
INPUT SOURCE on
remote controller
RETURN
OK
Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available.

4. Description of display

(1) Page/ of present number of total pages
No. Description
(1) Page/ of present number of total pages
(2) Page present title
(3) Input that has been selected now
(4) Present colour system
(5) Inducing display
(6) Model name
(7) Item name
(8) Parameter
Main unit key
Moving an item (line) by one (UP/DOWN)
P ( / )
VOL (+/-) Changing a selected item setting (+1/-1)
— Turning a page (PREVIOUS / NEXT)
— Changing a selected line setting (+10/-10)
— Input source switching (toggle switching) (TV→EXT1~8)
— Returning to a present page
— Executing a function
(3) Input that has been selected now
(2) Page present title
1/33 [INFO] INPUT1
MAIN Version
BOOT Version
Monitor Version
FRC Version
CPLD Version
EQ DATA CHECKSUM
LAMP ERROR
MONITOR ERR CAUSE
NORMAL STANDBY CAUSE
ERROR STANDBY CAUSE
(7) Item name
2char/2char Decimal Number mark.
It bundles it by Max. 15 char "[" "]".
TV/INPUT1/INPUT2/INPUT3/INPUT5/INPUT6/INPUT7/INPUT8
NTSC/PAL/SECAM/COMP15K/COMP33K/COMP45K/COMP28K/COMP31K
EUROPE/RUSSIA/SWEDEN
MODEL NAME
Max. 30 char
Max. 60 char
(5) Inducing display
(4) Present colour system
AUTO ???
1.00 (E 2007/07/10 D)
1.0
a6
ROM
0
11 11 11 11
0
1) 0 2) 0
0H 0M 0H 0M
4) 0 5) 0
0H 0M 0H 0M
(8) Parameter
Display specification
3 – 2
Function
(6) Model name
37E_X20
3) 0
0H 0M