Canon iR2200 Service Handbook page 184

CHAPTER 5 SERVICE MODE
<MISC>
Use it to make other adjustments.
If you have cleared the RAM on the DC controller PCB and replaced the PCB, be sure to
enter the settings indicated on the service label.
C1-ADJ-Y
Use it to enter the cassette 1 horizontal registration adjustment value.
• Enter a value in relation to the registered value for the laser write start
position for paper picked up from the cassette 1.
Range of -32 to + 32 (in steps; '1' step being 0.16 mm)
adjustment
C2-ADJ-Y
Use it to enter the cassette 2 horizontal registration adjustment value.
• Enter a value in relation to the registered value for the laser write start
position for paper picked up from the cassette 2.
Range of -32 to +32 (in steps; '1' step being 0.16mm)
adjustment
C3-ADJ-Y
Use it to enter the cassette 3 horizontal registration adjustment value.
• Enter a value in relation to the registered value for the laser write start
position for paper picked up from the cassette 3.
Range of -32 to +32 (in steps; '1' step being 0.16mm)
adjustment
C4-ADJ-Y
Use it to enter the cassette 4 horizontal registration adjustment value.
• Enter a value in relation to the registered value for the laser write start
position for paper picked up from the cassette 4.
Range of -32 to +32 (in steps; '1' step being 0.16mm)
adjustment
MF-ADJ-Y
Use it to enter the horizontal registration adjustment value for the
multifeeder.
• Use it to enter a laser write start position value in relation to the regis-
tered value for paper picked up from the multifeeder tray.
Range of -32 to +32 (in steps; '1' step being 0.16mm)
adjustment
5-56
COPIER>ADJUST>MISC