Log Placement - Vermont Castings Lexington LX32DV Installation And Operating Instructions Manual

LoG pLAceMeNt

Before you begin — This unit is supplied with eight ceramic fiber logs. Do not handle these logs
with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
the positioning of the logs is critical to the safe and clean operation of this
heater. excessive sooting and other problems may result if the logs are not
properly and firmly positioned in the appliance. Never add additional logs or
embellishments such as pine cones or vermiculite to the heater. only use the
logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only
parts specifically approved for this heater may result in property damage or
personal injury.
INStALL LoGS AND RocK WooL (eMBeR
MAteRIAL) IN FIReBoX
1. Carefully remove logs from wrapping.
2. Remove glass frame. Refer to Glass Frame Removal,
Page 27
51D0528
3. Place bottom right log (#3) on
two pins against right side of
firebox. Figure 38
Bottom Right Log
#3
Figure 38
Lg805
LX rear right log
LX Series Direct Vent Gas Fireplace
LG805
27