Troubleshooting; Mc45 - Motorola MC45 Integrator Manual

7 - 6 MC45 Integrator Guide

Troubleshooting

MC45

Troubleshooting the MC45
Table 7-1
Problem
MC45 does not turn
on.
Rechargeable battery
did not charge.
Cannot see
characters on
display.
During data
communication, no
data transmitted, or
transmitted data was
incomplete.
No sound.
Cause
Battery not charged.
Battery not installed
properly.
System crash.
Battery failed.
MC45 removed from
cradle while battery was
charging.
Extreme battery
temperature.
MC45 not powered on.
MC45 removed from
cradle or disconnected
from host computer during
communication.
Incorrect cable
configuration.
Communication software
was incorrectly installed or
configured.
Volume setting is low or
turned off.
Solution
Charge or replace the battery.
Install the battery properly. See
page 1-4.
Perform a warm boot. If the MC45 still does not turn on,
perform a cold boot. See Resetting the MC45 on page
1-8.
Replace battery. If the MC45 still does not operate,
perform a warm boot, then a cold boot. See
MC45 on page 1-8.
Insert MC45 in cradle and allow to charge.
Battery does not charge if ambient temperature is below
0°C (32°F) or above 40°C (104°F).
Press the red Power button.
Replace the MC45 in the cradle, or reattach the
communication cable and re-transmit.
See the system administrator.
Perform setup. Refer to the MC45 Integrator Guide for
details.
Adjust the volume.
Installing the Battery on
Resetting the