JVC VN-V686WPU Instructions Manual page 63

Jvc outdoor ptz ip dome camera instructions
Hide thumbs Also See for VN-V686WPU:
Table of Contents

Advertisement

A
Privacy Mask
B
Adjustment
Note :
● The tilt angle where mask can be set is within 40 degrees from the horizontal position.
● To change the privacy mask position to upper area from horizontal direction, press the up button until the
end of the horizontal position, release the button, and press it again. Only the privacy mask will be moved
to upper area. This will set the privacy mask at the area above the shallow horizontal position.
● The mask will appear larger than when it is set. If some area that you wish to hide appear due to the
camera direction or zoom, set the mask larger.
● The default home position is outside the range of the privacy mask.
● When the [Adjustment] window is first opened in the computer, ActiveX will be installed.
For specifying whether to activate the Privacy Mask feature.
When this is set to On , the privacy mask specified using the following
items will appear on the screen.
:
Memo
● When setting privacy mask, zoom will be at the Wide edge and [Digital Flip] is
set to Off .
This item adjusts the mask. Click this item to open the [Adjustment] screen.
To change the setting, first, enter [Operator Password] in the [Password]
screen. (A Page 34)
If the [Operator Password] was entered already to setting page of Built- in
Viewer, it will be displayed as ●●●●●●.
[Adjustment] screen
D [Position]
This sets the position to place the mask.
Set the moving speed in [Pan/Tilt Speed].
[Setting value : 1 to 8]
[Brightness] screen
This item sets the brightness (color) of the mask.
0 is black. The larger the number is, the closer the color is to white. When
the number is 10 , the color is white. You can check the color at [Image].
[Setting values : 0 to 10]
[Password] screen
Enter the Operator Password . (A Page 34)
A
[Adjustment], [Brightness], [Password] tab
Each setting screen appears.
B
[Mask]
When Off is selected, mask will not be
displayed on the screen.
[Setting values : 0 to 7]
C
[Size]
This item sets the size of the mask.
Use the [Shrink] or [Expand] button to set
the Hight or Width of the mask.

Advertisement

Table of Contents
loading

Table of Contents