Table of Contents
Advertisement
Connection/Installation
Mounting the Camera
(continued)
Mounting the Camera
1
Mounting the fall prevention wire
● Mount the fall prevention wire of the camera to
the fall prevention wire anchor bolt that was
installed earlier.
● Secure the fall prevention wire tightly with a nut
and washer.
2
Pull out the cables (from the wall)
from the cable connection hole.
3
Mount the camera to the wall
● Mount the camera to the camera anchor bolts
that were installed earlier.
● Secure the camera tightly with a nut and
washer.
1
Fall Prevention
2
Wire
Note ：
● This product weighs approximately 5.5kg. When
installing, pay extra attention to the fall.
● For your safety, hold the arm section during
installation.
● After installing, paint the nuts and washers to
prevent corrosion.
:
Memo
● To remove the camera, follow the reverse
procedures.
Washer
3
Nut
Cable Connection
1
LAN Cable Connection (A Page 22)
A Use the provided RJ-45 conversion connector
and connect the LAN cable.
B Wind the connector section with waterproof
tape (adhesive) and push the cable into the
arm of the camera.
B
Wind the
waterproof tape
(adhesive)
2
Connecting the power cable
(A Page 20)
Connect the power cable and wind the
waterproof tape (adhesive).
After connecting, push the cable into the arm of
the camera.
Wind the waterproof tape (adhesive)
Arm
A
RJ-45
conversion
connector
(provided)
Arm
Advertisement
Table of Contents
