Table of Contents
Advertisement
Connection/Installation
Mounting the Camera
Setting Up the Wall
Be sure to put on protective glasses to protect
your eyes from falling objects when mounting
the camera.
1
Make holes in the wall
Make holes (R 45 mm) for the connecting cables
to pass through.
Note ：
● Check the strength of the wall. A less firm wall
may cause the unit to fall.
2
Install the anchor bolts for mounting
the camera
Install 4 anchor bolts (M8
to mount the camera.
3
Install the anchor bolt for mounting
the fall prevention wire
Install the anchor bolt (M8
to mount the fall prevention wire 30 mm below
the center of the upper two anchor bolts that are
used to mount the camera.
152
126
63
3
Anchor bolt to
mount the fall
prevention wire
1
35 mm and above)
35 mm and above)
2
Anchor bolts to
mount the camera
4
Pull the cables from the hole in the
wall
Pull the power cable, LAN cable and alarm
signal cable from the wall.
Alarm signal cable
Setting Up the Camera
1
Remove the dome cover
Loosen the screws (x4) and remove the dome
cover from the camera.
LAN Cable
Power cable
Dome Cover
Advertisement
Table of Contents
