Toshiba 420CDT User Manual page 98

(d) Remove the source disk from the FDD, insert a formatted work disk and
press any key. The [[ track, head = XXX X ]] message will appear and
start copying to the target disk. When the amount of data is too large to be
copied in one operation, the message from step (b) is displayed again. After
the floppy disk has been copied, the following message will appear:
Copy complete
Another copy (1:Yes/2:No) ?
(e) To copy another disk, type 1 and the message from step (a) will be displayed
again. Entering 2 returns the test program to the DIAGNOSTIC MENU.
4. DUMP program
(a) When dump is selected, the following message appears:
DIAGNOSTICS-HARD
Drive type select (1:FDD, 2:HDD) ?
(b) Select a drive type. If 1 is selected in step (a), the following message dis-
plays:
Select drive number
Select an FDD drive number. The display will go to step (c).
If 2 is selected, the following message displays:
Select drive number
After selecting the HDD, the display will go to step (f).
(c) The following message will be displayed:
Format type select (1:2DD, 2:2D, 3:2HD) ?
(d) Select a format type. The following message will appear:
Insert source disk into drive A:
Press any key when ready.
(e) Insert a source disk and press any key.
(f) The following message will appear:
—— Max. address ——
Set the track number you want to dump. The system will access the disk and
dump a list.
3-52
DISK & FLOPPY DISK DUMP : VX.XX
(1:A, 2:B) ?
(1:C, 2:D) ?
[Track ] = XXXX
[ Head ] = XX
[Sector] = XX
Track number ??
420 Series