Toshiba 420CDT User Manual page 128

9. Disconnect the flexible cable.
10. Remove four M2x3 screws and remove the FDD from the bracket.
Installing the FDD
To install the FDD, follow the steps below and refer to Figures 4-12 back through 4-9.
1. Seat the FDD in the metal bracket and secure four M2x3 screws.
2. Connect the flexible cable.
3. Seat the FDD in the lower plastic cover and set the plate in place.
4. Set the upper plastic cover in place and secure two M2x6 screws and four M2x3
screws.
5. Slowly insert the FDD module into the computer. Be careful to insert the drive
straight and press gently so the drive is flush with the computer.
6. Hold the FDD module flush to the computer and push the lever down until it
snaps into place.
7. Lock the release lever lock.
8. Install the optional memory module, optional PC card, and battery pack as
described in Sections 4.4, 4.3, and 4.2.
4-14
Figure 4-12 Removing the FDD
420 Series