Toshiba 420CDT User Manual page 160

420 series
Hide thumbs Also See for 420CDT:
Table of Contents

Advertisement

4.
Carefully rotate the LCD module out of the LCD cover and lay it on the
keyboard.
5.
Disconnect the flexible display cable from the display unit and disconnect four
display cables from PJ2, PJ3, PJ4, and PJ5 on the flexible cable.
6.
Remove the shielded tape securing the display cables to the LCD cover.
Installing the LCD Module
To install the LCD module, follow the steps below and refer to Figures 4-46 and 4-45.
1.
Secure the display cable to the LCD cover with shielded tape.
2.
Connect the display cables to PJ2, PJ3, PJ4, and PJ5 on the flexible cable and
connect the flexible cable to the display module.
3.
Carefully rotate the LCD module into the LCD cover. Be sure the flexible cable
fits securely into the clear plastic protector.
NOTE: Support the back of the display with your hand when you secure the
screws.
4.
Secure four M2.5x6 screws with ground cable on the LCD module. Make sure
the ground cable is secured at the lower left corner.
5.
Install the FL inverter board, display mask, optional memory module, optional PC
card, and battery pack as described in Sections 4.17, 4.16, 4.4, 4.3, and 4.2.
4-46
Figure 4-46 Removing the LCD module (TFT)
420 Series

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

420cds420cd

Table of Contents