Toshiba 420CDT User Manual page 136

Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figures 4-21 back through 4-18.
1. Connect the keyboard cable to PJ13 on the system board. Make sure the pressure
plate connection on the cable is secure.
2. Fit the two tabs of the metal cover into the top cover and backup battery base (see
Figure 4-21), then seat the metal cover and secure it with five M2.5x6 screws.
Make sure the plastic tab on the LED connector is under the metal cover.
3. Fit tabs on the back of the keyboard into corresponding holes on the computer and
lay the keyboard in place.
4. Secure six latches on the back of the keyboard base, two latches at the ends, and
six latches along the front.
5. Install the HDD, FDD or CD-ROM drive, optional memory module, optional PC
card, and battery pack as described in Sections 4.7 back through 4.2.
4-22
Figure 4-21 Seating the metal cover
420 Series