Maytag ADE7005AK Service Service Manual page 13

Troubleshooting Procedures
Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or
repair of this unit.
To avoid risk of electrical shock, personal injury or death; disconnect power and shut off gas to unit before servicing,
unless testing requires power.
ENTER SERVICE MODE
EXIT SERVICE MODE
DISPLAY/CLEAR SERVICE CODES
©2006 Maytag Services
!
Rotate the Cycle Selector Knob to the "Power Off"
position and press knob.
(All LED's will be off).
Rotate the Cycle Selector Knob clockwise past
"Power Off" twice and stop at "Regular".
(LED's will illuminate as the knob is rotated).
Rotate the Cycle Selector Knob counterclockwise
one revolution back to "Regular" and press knob.
•
Power Off LED will blink. Regular LED will be
illuminated.
•
Model I.D. is displayed by the LED's around the
bottom of the dial.
•
Model I.D. can be redisplayed while in Service
Mode by setting knob to "Delicate" and
pressing.
•
Refer to chart for Model I.D.
Rotate Cycle Selection Knob to "Power Off" and press
knob.
or
Allow 5 minutes of inactivity.
or
Disconnect power
Enter Service Mode then set Cycle Selection Knob to
"Time Dry 10". Press knob.
•
Time Dry 10 LED will blink if codes other than
power interrupt are present.
•
Press knob to view codes. Press once for each
code. Codes are displayed newest to oldest.
Machine beeps three times after last service code is
displayed.
•
To clear codes display a code then press and hold
Cycle Selection Knob until machine beeps twice.
Time Dry 10 LED stops blinking.
•
Refer to chart for Service Codes.
WARNING
16026315 11