2-11-8. SV-164 Board
1. Open the right panel. (Refer to section 2-2-2.)
2. Remove the ES-21/21P and DPR-99/99P boards.
(Refer to section 2-11-4.)
3. Remove the screw (B2.6 x 4) and remove the dust-
proof sheet.
4. Disconnect the two flat cables (CN501 and CN502) and
two flexible cards (CN504 and CN505) from the SV-
164 board.
5. Remove the three screws (PWH1.4 x 2.5), disconnect
the connector CN500, and remove the SV-164 board.
Point to notice when disconnecting the connector:
In order to prevent the board from damage, pull out the
connector CN500 gradually.
Point to notice when connecting the connector:
Be sure not to apply excessive force to the component side
of the SV-164 board when connecting the connector
CN500.
Point to notice when removing/installing the board:
Be very careful not to damage the connectors, harnesses,
and flexible card boards that are connected to the MB-753
board.
2-20
Dust-proof sheet
Screw
PWH1.4 x 2.5
Screw
CN500
MB-753 board
PWH1.4 x 2.5
SV-164 board
CN502
B2.6 x 4
CN505
CN504
CN501
DSR-300/P(E)/V1