System Setting Menu - Sony DSR-300 Service Manual

5-2. SYSTEM SETTING MENU

The tape path system adjustment is performed by setting
the following system setting menu.
No. 604 tracking adjustment:
Performs recording and playback in
the central ITI mode.
This mode is effective only when the
power is ON.
When the power is turned OFF, it is
automatically set to OFF.
No. 605 switching position adjustment:
Performs automatic adjustment of the
switching position.
The method of setting menu No. 604 is as follows.
(Refer to Section 5-8 for how to set menu No. 605
"Switching position adjustment.")
WARNING
RESET
RESET
(MENU SET)
button
(MENU SET)
REC TIME SKIN DTL EXT VTR MENU ADVANCE
OUTPUT
TTL
ON COMPONENT.
DUR VBS
OFF
OFF Y/C
TTL RESET SET
MONITOR SELECT PRESET
VTR
TRIGGER CH-1
MIX
CH-2
PARALLEL
EXT
INT ONLY
DATE/TIME
EXT ONLY
HYPER MATRIX
ClipLink
FRONT MIC
GAIN
CONTINUE
LOW CUT
H.SAT
ON
FL ON
OFF
STD
OFF
MENU button
ADVANCE button
5-4
Display window (LCD)
LIGHT
OVER dB OVER
PB DATE NDF EXT-LK HOLD
ON
0
OFF
-12
H MIN SEC FRM
-20
CLIP CL CONT IP
DISPLAY
-30
TAPE DVCAM
COUNTER
-40
BATT E F Li
∞ TC
-
F U-BIT
DIAG 1 8 32k 2
RF SERVO HUMID SLACK
F
8 48k
SHIFT
AUDIO LEVEL
F-RUN F-RUN
AUTO
MAN
AUDIO SELECT
REGAIN SET
CH-1 CH-2
LITHIUM BATT
R-RUN
AUDIO IN
MONITOR OUT
FRONT
CHARACTER
VJ MIC
WRR
REAR
ON
OFF
SHIFT button
1. Set the maintenance menu, and select Menu No. 601.
(1) Press the MENU button while pressing the SHIFT
button, then release the SHIFT button first, and release
the MENU button after more than 1 second.
The display window (LCD) will display as follows.
(Characters underlined on the display window (LCD)
in the description of operations hereafter indicate that
they are blinking.)
(2) Press the RESET (MENU SET) button once so that
"oFF" blinks.
The display window (LCD) will display as follows.
Each time the RESET (MENU SET) button is pressed,
"600" and "oFF" will blink alternately.
(3) Press the ADVANCE button once, and select "on."
The display window (LCD) will display as follows.
Each time the ADVANCE button is pressed, "on" and
"oFF" will blink alternately.
(4) Press the RESET (MENU SET) button once.
The display window (LCD) will display as follows.
Each time the RESET (MENU SET) button is pressed,
"600" and "on" will blink alternately.
DSR-300/P(E)/V1