Oki MC560 MFP CX2032 Service & Troubleshooting Manual page 11

REPLACE IMAGE DRUM
%ERRCODE%:%COLOR% DRUM
LIFE
REPLACE IMAGE DRUM
%ERRCODE%:%COLOR% DRUM
LIFE
REPLACE FUSER
%ERRCODE%:FUSER LIFE
REPLACE BELT
%ERRCODE%:BELT LIFE
REPLACE BELT
%ERRCODE%:BELT LIFE
CHECK TONER CARTRIDGE
%ERRCODE%:%COLOR%
IMPROPER LOCK LEVER POSITION
CHECK IMAGE DRUM
%ERRCODE%:%COLOR% DRUM
MISSING
CHECK IMAGE DRUM & BELT LOCK
%ERRCODE%:K DRUM MISSING
CHECK FUSER
%ERRCODE%:FUSER MISSING
CHECK BELT
%ERRCODE%:BELT MISSING
POWER OFF AND WAIT FOR A
WHILE %ERRCODE%:MOTOR
OVERHEAT
CLOSE COVER
%ERRCODE%:COVER OPEN
CLOSE COVER
%ERRCODE%:DUPLEX COVER
OPEN
The life of the image drum (Alarm)
350 Error 350 : Y
351 Error 351 : M
352 Error 352 : C
353 Error 353 : K
Warning status takes effect at Cover Open/Close.
The toner empty error is occurred after the image drum reached its life.
Error 560 : Y
560
Error 561 : M
561
Error 562 : C
562
Error 563 : K
563
This is displayed until a user exchanges the image drum.
Notifies the fuser has reached its life. This is the error displayed based
on the counter to indicate that the fuser has reached its life, and
354 printing will stop. Warning status takes effect at Cover Open/Close.
This error will occur on some user setting mode.
Notifies the transfer belt has reached its life. This is the error displayed
based on the counter to indicate that the belt has reached its life, and
355
printing will stop. Warning status takes effect at Cover Open/Close.
Indicates waste toner full. Warning status takes effect only once at
Cover Open/Close, and the error occurs again when about 500 copies
356
have been printed.
Shows that the toner cartridge lever has not been locked.
544
Error 544 : Y
545
Error 545 : M
546
Error 546 : C
547
Error 547 : K
The image drum is not correctly installed.
340 Error 340 : Y
341 Error 341 : M
342 Error 342 : C
Indicates that the belt is unlocked or the black image drum is not set
343 properly.
The fuser unit is not correctly installed. (This error is likely issued when
320 the printer is cool at 0 degrees C or lower. Turn on the power again
after the printer has warmed up.)
330 The belt unit is not correctly installed.
321 Motor Driver IC overheat is detected.
The cover is open.
310 Error 310 : Top Cover
311 Error 311 : Front Cover
The cover is open.
316 Error 316 : Duplex Unit
11