Front height
C4CP0N2C
Measure the dimension R1.
Measure the dimension R2.
Compress the suspension until the calculated values «H1» and «H2» are obtained.
NOTE : The difference in height between the two sides at the rear should be less than 7.5 mm.
AXLE GEOMETRY
Geometry of the axles at reference height.
H1 = R1 – L1
H1 = Distance between the ground and
the mounting face of the fixings.
R1 = Distance between the centre of
the front wheel and the ground.
L1 = Distance between the centre of the
front wheel and the mounting face of
the fixings.
The values L1 and L2 are given in the table below.
Normal suspension
Front axle
Dimension
L1
Value (mm)
71 ± 10 mm
Calculate the dimension H1 = R1 - L1.
Calculate the dimension H2 = R2 + L2
H2 = R2 + L2
H2 = Distance between the ground
and the mounting face of the rear
crossmember.
R2 = Distance between the centre of
the rear wheel and the ground.
L2 = Distance between the centre of the
rear wheel and the rear crossmember.
Raised suspension
Rear axle
Front axle
L2
L1
53 ± 6 mm
36 ± 10 mm
251
SAXO - All Types
Rear height
Rear axle
L2
82 ± 6 mm
C4CP0N3C