Heatilator CNXT4236IT-C Owner's Manual page 71

B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
15-1/8 in.
(384 mm)
(305 mm)
6-3/8 in.
163 mm
4 in.
102 mm
8-1/8 in.
206 mm
Figure 16.8 SLP Series Vent Components
Heatilator • CNXT4236IT-C, CNXT4842IT-C, CNXT4236IH-C, CNXT4842IH-C • 2208-900 Rev. M • 7/14
8 in.
(203 mm)
12 in.
SLP-TRAP
Horizontal Termination Cap
13 in.
330 mm
13 in.
330 mm
SLP-DCF-BK
Ceiling Firestop
Black
14-7/16 in.
367 mm
14-7/16 in.
367 mm
SLP-WT-BK
Wall Thimble-Black
4-5/8 in.
117 mm
DVP-2SL
Adapter
Heat
Shield
Term Cap
Max
Effective
Length
1-5/16 in.
34 mm
2-5/16 in.
59 mm
4-3/16 in.
106 mm
5-1/16 in.
128 mm
Minimum Maximum
Effective Length Effective Length
3-1/8 in.
Trap1
79 mm
5-1/4 in.
Trap2
133 mm
14 in.
356 mm
10-9/16 in.
269 mm
SLP-CCS-BK
Cathedral Ceiling
Support Box-Black
12 in.
305 mm
12-1/2 in.
318 mm
SLP-TVHW
Vertical
Termination Cap
26 in.
660 mm
DVP-HSM-B
Extended Heat Shield
4-3/4 in.
121 mm
9-1/4 in.
235 mm
71