Sony DCM-M1 Service Manual page 162

6) Check that the name associated with the pressed key is dis-
played at part if a key on the set is pressed. (See Table
C
below)
Display Key name
u (PLAY/PAUSE)
PLAY
x (STOP)
STOP
> (FF)
FF
. (REW)
REW
SLOW y (SLOW)
A REC AUDIO REC
V REC (VIDEO REC)
PON ENTER
ERASE ERASE
MENU MENU
BRIGHT EXPOSURE
DISPLAY DSPL
VOLUME + e (VOL +)
E (VOL –)
VOLUME –
PHOTO PHOTO
MARK BACK LIGHT
FORCUS FORCUS
7) Check that the "KEY CHECK MODE" characters on the screen
change to green in color if all keys on the set are pressed.
3. Adjustment Condition Check
In the Adjustment Condition Check mode, current conditions of
servo auto adjustment, MAC address setting, and touch panel po-
sition alignment can
be checked.
1) Select the item number "7-02-05".
2) Press u key to activate the Adjustment Condition Check
mode.
(When the Adjustment Condition Check mode becomes ac-
tive, the screen changes as shown in Fig.7-1-31, and current
adjustment conditions are displayed)
Adjust Condition
MO CD
MD1 --
MD2 OK NG
Correct a location of Touch Panel
NG
Write MAC address
OK
Condition display of MAC address setting
Condition display of
touch panel position alignment
Condition display of servo auto adjustment
• escription of display
OK ........... Adjustment successfully completed
NG ........... Adjustment failed (or not adjusted yet)
– ............... Not adjusted yet (Servo auto adjustment only)
• Key operation
x key ....... Releases the Adjustment Condition Check mode
y key ..... Initializes the Adjustment Condition Check mode
If y key is pressed, the condition display of servo auto adjust-
ment will be all "–", and that of MAC address setting and touch
panel position alignment will be "NG". (Fig.7-1-31)
Note: The adjustment data are not initialized even if the Adjust-
ment Condition Check mode is initialized.
4. Set Value Initializing
Each set value on the set can be initialized to the factory setting.
Initializing method
1) Select the item number "7-02-06".
2) Press y key, and "OK" will be displayed on the screen and
each set value will be initialized to the factory setting.
– 22 –
OK
Fig.7-1-31