Sony DCM-M1 Service Manual page 159

2. MAC Address Setting Method
1) Select the item number "7-01-01".
2) Press u key to activate the MAC Address Set mode.
(When the MAC Address Set mode becomes active, the MAC
address is displayed as shown in Fig.7-1-24)
TEST MODE
ITRON
Drive
JAVA APP
JAVA OS
BOOT
IPL
RATE CTL
Item No.
7–01–01
Other
MAC Address Write
MAC 08 : 00 : 46 : ss : ss : ss
Moves the cursor by . key
MAC 08 : 00 : 46 : ss : ss : ss
Moves the cursor by > or u key
Fig.7-1-24
3) Operating the keys on the set, set the MAC address.
Note: Set the address values at three places on the right side.
Three address values on the left side are fixed values
and not changeable.
• Key operation
> or u key ...... Moves the cursor to the right.
. key ................. Moves the cursor to the left.
e key ..................... Increases address value at the cursor position.
E key ..................... Decreases address value at the cursor position.
x key ...................... Releases the MAC Address Set mode.
y key .................... Writes MAC address.
4) Press y key to write the MAC address.
Note: Even if the y key is pressed, the screen does not
change. Unless this key is pressed, the set MAC address
is not stored in nonvolatile memory.
Also, the MAC address writing can be done only once
after the power was turned on. To set the MAC address
once more, the power must be turned off, and on again.
made by MD dep.
Ver. s. sss
Ver. s. sss
Ver. ssssssss
Ver. ssssssss
Ver.
s. sss
Ver. s. sss
Ver.
s. sss
Adjust
– 19 –