Playback With Hdd Navigation - JVC HM-HDS1U Instructions Manual

Playback
with HDD
Navigation
The following screen appears as the HDD Navigation screen when you press NAVI with the HDD deck selected. You
can move the arrow to select the desired position on the screen by pressing @%#fi (or 253∞). When you move the
arrow at the top of the HDD Navigation screen, you can change the screens by pressing @# (or 23).
You need to select
"SCAN" to scan the
beginning of the
programs.
TOTAL TIME : for the
selected programs
Index : small still
picture of the each
program
Recording Informa-
tion for the program
indicated by the
arrow
Operational
commands
Guidance for
operations
HDD NAVI
SCAN EASY DUBBING
TOTAL TIME 0H00M REMAIN TIME 11H07M (SP)
06/12/01 TUE 06/12/01 TUE
06/12/01 TUE 10:30AM – 12:55PM 2CH SP 145min
PLAY MODIFY
INDEX NAVI
SELECT WITH [∞523]
THEN PRESS
SELECT OK END
The Icons and their meanings
You cannot dub this program from the HDD deck
to the VHS deck.
This program was recorded with Daily mode of
D
Timer recording.
This program was recorded with Weekly mode of
W
Timer recording.
This program has stereo sounds.
ST
This program has SAP audio.
SA
This program was recorded with Timer recording.
The HDD Navigation enables you to seach and select
the desired programs recorded on the HDD deck very
easily.
There is a 40 Gbyte hard disk drive on this recorder. You
can record up to 60 programs for the HDD deck.
Each time a program is recorded on the HDD deck, the
information of the program are registered in the HDD
Navigation automatically.
So, you can confirm the information of the programs
recorded on the HDD with the HDD Navigation Screen.
And, you can also select one of the programs recorded
on the HDD deck using the HDD Navigation.
EDITING
3 / 6
D W
06/11/01 MON 06/11/01 MON
[MISC.]
ST
DELETE CANCEL
[OK]
25
EN
REMAIN TIME : it is
based on the
recording speed
currently selected.
There are 6 recorded
programs and the
program indicated by
the arrow is the 3rd
one.
This appears when
there are over 4
registered programs.
You can select the
other program by
pressing @# (or 23).
The icons : they show
the recording situation
for each program.