Four.position.ignition.switch; Emergency.stop.switch - Four winns 310 Horizon Owner's Manual

Table of Contents

Advertisement

.
NOTE:.Once.a.keel.offset.is.programmed,.the..
shallow.and.deep.alarms.will.be.activated.by.the.
depth.below.the.keel.
4.. Units. pressing the " O N / O F F MODE" keypad
again displays "Un" on the LCD indicating the units
mode..Press.either.the.up.or.down.arrow.keypads.
to.set.the.units.desired.to.feet.(FT),.meters.(M),.
or.fathoms.(F)..These.units.once.set,.will.remain.
the.same.for.all.modes..Pressing.the."ON./.OFF.
MODE" keypad again returns the depth sounder .
to.normal.operation.
Do not rely on depth sounder to avoid sub-
merged objects. Depth sounders provide a
relative indication of water depth only.
NOTICE
DO NOT depend solely upon the depth
sounder for water depth. It is important to have
navigational charts of the waters in which you
are operating.
I.
Four Position Ignition Switch
Most.models.use.an.ignition.switch.with.four.positions:.
OFF,.RUN,.ACCESSORIES,.and.START..Just.like.
the.three.position.switch,.the.START.position.is.spring.
loaded.and.the.key.should.be.held.in.this.position.
until.the.engine.starts..The.key.will.return.to.the.RUN.
position.once.released..Always.turn.the.key.to.the.
OFF.position.when.the.engine.is.not.running..This.will.
prevent.discharging.of.the.battery(s)..The.ACCES-
SORIES.position.allows.the.operator.to.run.the.stereo.
without.activating.the.other.ship's.systems..Additional.
information.on.ignition.switch.operation.is.covered.in.
Section.A.Operation,.of.this.manual..
J. Emergency Stop Switch
This.safety.device.automatically.stops.the.engine.if.
the.lanyard.is.attached.to.the.operator.and.the.
operator.falls.from.his.work.station..Refer.to.the.
engine.manual.for.detailed.information.about.using.
this.switch.
The.emergency.stop.switch.(Figure.E7).incorporates.
a.shutoff.switch,.switch.clip,.lanyard,.and.lanyard.clip..
The.lanyard.clip.must.be.securely.attached.to.the.op-
erator's.PFD,.clothing,.arm,.or.leg..Be.sure.to.attach.
the.lanyard.to.a.place.where.it.is.free.of.obstructions.
Engines and Instrumentation - Section E
and.to.something.that.will.move.with.the.operator.if.
he.or.she.leaves.the.helm.station..If.the.engine.shuts.
down.because.this.switch.was.activated,.the.clip.may.
have.to.be.reinstalled.on.the.interrupter.switch.before.
the.engine.can.be.started.
Keep emergency stop switch lanyard free from
obstructions that could interfere with its opera-
tion. Do not modify or remove emergency
stop switch or bypass its safety features. The
proper use of the emergency stop switch will
prevent a runaway boat situation which can
cause severe personal injury or death.
Figure E7: Emergency Stop Switch
..
The.emergency.stop.switch.can.only.be.effective.
when.in.good.working.condition..Observe.the..
following:
1.. Lanyard.must.always.be.free.of.entanglements.
that.could.hinder.its.operation.
2.. Once.a.month,.check.the.switch.for.proper.opera-
tion..With.engine.running,.pull.lanyard..If.the.en-
gine.does.not.stop,.see.your.Four.Winns.Dealer.
3.. Once.a.month,.inspect.both.the.clip.and.lanyard..
for.cuts,.breaks.or.wear..Replace.worn.or.dam-
aged.parts.
In.an.emergency.situation,.any.occupant.of.the.boat.
can.restart.the.engine..Just.press.in.and.hold.the.
emergency.stop.switch.button,.then.follow.normal.
starting.procedures..When.the.button.is.released,..
the.engine.will.stop..
Owner's Manual Page 

Advertisement

Table of Contents
loading

Table of Contents