Table of Contents
Advertisement
4.. Extend.the.bimini's.secondary.bow,.by.pressing.
in.on.the.button.and.simultaneously.extending.the.
bow.until.the.button.locks.into.the.upper.position..
Repeat.for.the.other.side..
To.close.and.boot.(mounted.storage).the.bimini.top:
1.. Place.secondary.bow.into.lower.position.by.press-
ing.in.on.the.button.and.simultaneously.pulling.the.
bow.downward.until.the.button.locks.into.the.lower.
position..Repeat.for.the.other.side.
2.. Remove.the.forward.brace.rod.from.its.deck.
mounts..Snap.the.forward.brace.rods,.into.storage.
clips.for.safe.keeping.while.booted..
3.. Place.boot.over.bimini.top.and.zip.boot.closed..
Tucking.the.bimini.top.inside.boot.while.zipping.is..
required..See.Figure.O2.
Figure O2: Bimini Top Booted
You.may.choose.to.run.your.310.Horizon
bimini.top.either.fully.deployed.or.folded.together.
(closed).and.secured.with.the.boot.provided..Either.
way.it.is.designed.to.remain.mounted..No.storage.is.
provided.for.this.top.in.your.boat.
NOTICE
Use two people to remove the bimini top (win-
ter storage). This will help minimize the risk of
injury and help prevent damage to the uphol-
stery, the bimini top, and/or the boat.
Sport Boat Weather Covers - Section O
Aft/Main bimini canvas deployment should
only be utilized at or below moderate cruising
speed (approximately 0-0 mph). Avoid full
throttle operation of boat while having canvas
deployed. Four Winns recommends booting
the canvas before running at or close to maxi-
mum speed. In so doing you will help to main-
tain the life of the canvas and hardware. Also,
the wind should be taken into consideration
when determining operating speed with canvas
deployed. The boat speed plus (+) wind speed
should not be exceed 0 mph.
B. Camper Canvas (Optional)
The.camper.canvas.is.an.option.available.on.the.310.
Horizon™ models which encloses the cockpit area
and.allows.for.overhead.space..The.camper.utilizes.
the.existing.bimini.top..Covers.roll.up.to.expose.the.
window.screens..See.Figure.O2..Your.Four.Winns.
dealer.can.assist.you.with.your.canvas.selection.as.
well.as.the.installation.
To.install:
1.. Install.bimini.top.as.previously.instructed..
2.. To.ease.installation.of.the.windshield.connector,.
lock.the.secondary.bow.into.its.lower.position.by.
pressing.in.on.the.button.and.simultaneously.pull-
ing.the.bow.downward.until.the.button.locks.into.
the.lower.position..Repeat.for.the.other.side.
.with.the.
™
3.. Snap.the.lower.portion.of.the.windshield.connector.
to.the.windshield.frame.
4.. Zip.forward.windshield.connector.section.to.the.
bimini.top.
5.. Extend.the.bimini's.secondary.bow,.by.pressing.
in.on.the.button.and.simultaneously.extending.the.
bow.until.the.button.locks.into.the.upper.position..
Repeat.for.the.other.side..
6.. Partially.zip.in.the.bimini.side.curtains.to.the.bimini.
top (approximately 6"). Snap canvas to windshield
beginning.at.forward.edge..Finish.zipping.curtains.
to.bimini.top.after.snapping.is.complete.
7.. Attach.camper.bow.extension.to.existing.bimini.
bow.if.not.already.done..
NOTICE
Owner's Manual Page
Advertisement
Table of Contents
