Fixing of the loading floor
Fig. 156 Loop for raising the loading floor/Fixing the loading floor with a
plastic hook
You can fix the loading floor with a hook on the top edge of the boot lid cutout, in
order to e. g. reach the spare wheel.
›
Raise the loading floor at the loop
is located below the loading floor edge) to the top edge of the tailgate cut-
out
» Fig. 156
- .
Adjustment of the safety partition
Fig. 157 Top/lower support of the safety partition
Only valid for some countries.
›
Raise the loading floor part behind the safety partition.
›
On each side in the upper area of the body, undo and remove a bolt
and undo and remove a bolt in the lower area
178
Praktik
» Fig. 156
- and fix it with a plastic hook (it
» Fig. 157
» Fig. 157
- .
›
Move the safety partition into the required position. Ensure it is always move
the same distance- the same number of holes on both sides both upwards and
downwards.
›
On each side in the upper area of the body, undo and remove a bolt and undo
and remove a bolt in the lower area.
›
Have the tightening torque of the bolts checked with a torque wrench as soon
as possible. The tightening torque must be 20 Nm.
›
Change the position of the cover of the luggage compartment floor behind the
safety partition so that it lines up with the new position of the safety partition.
›
Fold back the loading floor part.
Emergency unlocking of the loading area door
If there is a fault in the central locking, you can unlock the loading area door as
follows:
›
Pull the control cable towards you and pull on it.
›
Press on the loading area door to open it.
›
Press the control cable back again.
-
Fig. 158
Emergency unlocking of the
loading area door