Changing A Wheel - Skoda Roomster Owner's Manual

›
Replacement bulb set;
›
Screwdriver.
Before placing the lifting jack back into its storage area, screw in the arm of the
lifting jack fully.
WARNING
The factory-supplied lifting jack is only intended for your model of vehicle.
■
Under no circumstances attempt to lift heavier vehicles or other loads - risk of
injury!
Ensure that the vehicle tool kit is safely secured in the luggage compart-
■
ment.
Note
Ensure that the box is always secured with the strap.

Changing a wheel

ä
Introduction
This chapter contains information on the following subjects:
Preliminary work
Changing a wheel
Subsequent steps
undoing and tightening wheel bolts
Raising the vehicle
Securing wheels against theft
160
Do-it-yourself
WARNING
If you are in flowing traffic, switch on the hazard warning light system and
■
set up the warning triangle at the prescribed distance! The national legal re-
quirements must be observed. In this way you are not only protecting yourself
but other road users as well.
If the wheel is damaged or in the event of a puncture, park the vehicle as far
■
away as possible from the flow of traffic. Park on as flat and firm a surface as
possible.
If the wheel has to be changed on a slope, first of all block the opposite
■
wheel with a stone or similar object to prevent the vehicle from unexpectedly
rolling away.
If the vehicle is subsequently fitted with tyres which are different to those it
■
was fitted with at the works, follow these guidelines
and tyres.
Always raise the vehicle with the doors closed.
■

Never position any body parts, such as arms or legs under the vehicle, while
■
the vehicle is raised with a lifting jack.
Secure the base plate of the lifting jack with suitable means to prevent pos-
■
sible moving. A soft and slippery ground under the base plate may move the
lifting jack, causing the vehicle to fall down. It is therefore always necessary to
place the lifting jack on a solid surface or use a wide and stable base. Use a
non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled
stones, tiled floor, etc.
Never start the engine with the vehicle sitting on the raised jack - danger of
■
161
suffering injury.
161
Only attach the lifting jack to the attachment points provided for this pur-
■
161 pose.
162
162
CAUTION
163
The prescribed tightening torque of the wheel bolts for steel and light alloy
■
wheels is 120 Nm.
If the anti-theft wheel bolt is fastened too tightly, it can cause damage to the
■
anti-theft wheel bolt and adapter.
Note
The anti-theft wheel bolt set or adapter set can be purchased from a ŠKODA
■
Service Partner.
The national legal requirements must be observed when changing a wheel.
■
» page 153, New wheels
