Table 22: Phone Number Control Characters; Table 23: Phone Number Assistance Keys - Bosch FPD-7024 Operation And Installation Manual

.

Table 22: Phone Number Control Characters

Press
[TEST] 1
[TEST] 2
[TEST] 3
[TEST] 4
Several keys assist when you enter phone or IP numbers (refer to Table 23 on page 59).

Table 23: Phone Number Assistance Keys

Press
[SILENCE]
[DISABLE]
[RESET]
If the wait for dial tone is not specified, the control panel waits 7 sec after going off-hook, and then
dials whether or not the dial tone is present.
For a phone number, you must enter 1 as a prefix before the special character >. Except for
unusual situations, all phone numbers should have the wait for dial tone character as the second
digit. This ensures that reports are delivered as quickly as possible, even if an incoming phone call
must be disconnected. For example, you would program 1>18002890096 for the phone number
1-800-289-0096.
To enter a central station IP address in either phone number 1 or 2 in the control panel, replace all three
phone numbers with an IP address. To distinguish an IP address from a phone number, enter 0 as the first
digit, followed by the 12 digit IP address.
The IP address must be 12 digits long.
For example, if the IP address is 172.30.1.101, the phone number is programmed as 0 172 030
001 101. Do not add the spaces. They are included for readability.
Bosch Security Systems, Inc. | 1/10 | F01U008458-03
FPD-7024 | Operation and Installation Guide | 5.0
See
*
#
/
>
Control Panel Programming
Action
Touch Tone "*"
Touch Tone "#"
Three-second delay
Wait for dial tone
Action
Advance to next position
Go back one position
Clear position
59