Specifications - Icom IC-M602 Service Manual

SECTION 1
' ' GENERAL
• Frequency coverage
• Mode
• Usable channels
• Power supply requirement
• Usable temperature range
• Current drain (at 13.8 V DC)
• Antenna connector
• Dimensions (projections not included)
• Weight
' ' TRANSMITTER
• Output power (at 13.8 V DC)
• Modulation
• Maximum frequency deviation
• Frequency error
• Spurious emissions
• Adjacent channel power
• Residual modulation
• Audio harmonic distortion
• Audio frequency response
• Microphone impedance
' ' RECEIVER
• Receive system
• Intermediate frequencies
• Sensitivity
• Squelch sensitivity
• Adjacent channel selectivity
• Spurious response
• Intermodulation rejection ratio
• Hum and noise
• Audio output power (at 13.8 V DC)
• Audio frequency responce
• GPS interface
1 2
* For Channel 70 only, * For other channels
Specifications are measured in accordance with TIA/EIA 603
All stated specifications are subject to change without notice or obligation.

SPECIFICATIONS

: 156.020–157.425 MHz (Tx)
156.050–163.275 MHz (Rx)
: 16K0G3E (FM) / 16K0G2B (DSC)
: All international, U.S.A and Canadian channels, plus, 10 Weather channels
: 13.8 V DC ±15 % (negative ground)
: –20˚C to +60˚C; –4 ˚F to +140 ˚F
: Transmit
Receive
: SO-239 (50 Ω)
: 220(W)×110(H)×109.4(D) mm; 8
: 1350 g; 2.97 lb
: High
Low
: Variable reactance frequency modulation
: ±5.0 kHz
: ±0.3 kHz
: Less than –70 dBc
: More than 70 dB
: More than 40 dB
: Less than 10% at 60% deviation
: +1 dB to –3 dB of 6 dB octave from 300 Hz to 3000 Hz
: 2 kΩ
: Double conversion superheterodyne system
: 1st
2nd
: Less than –10 dBµ at 12 dB SINAD
: Less than –10 dBµ at threshhold
: More than 80 dB
: More than 80 dB
: more than 80 dB
: More than 40 dB
: 5.0 W at 10% distortion with a 4 Ω load
: +1 dB to –3 dB of –6 dB octave from 300 Hz to 3000 Hz
: NMEA0183 Ver. 2.0 or 3.01
at 25 W 5.2 A typical
max. audio 1.2 A typical
21
⁄
32
25 W
1 W
1
21.7 MHz* , 31.05 MHz*
450 kHz
1 - 1
× 11 × 5
(W) 4 ⁄ (H) 4 ⁄ (D) inch
32 16
2