Maintenance; Cleaning Your Heater; Yearly Service Procedure - Lopi Heritage-2000 Owner's Manual

24

Cleaning Your Heater

Warning: Fingerprints or other marks left on the optional gold surface may become etched in place if they are not
wiped clean prior to turning the stove on.
With the heater cool, use denatured alcohol and a soft cloth to clean gold surfaces. Other cleaners may leave a
film that may become etched into the gold.

Yearly Service Procedure

Warning: Failure to inspect and maintain the heater may lead to improper combustion and a potentially dangerous
situation. We recommend the following procedures be done by a qualified technician.
1 Check the pilot flame. It should engulf approximately 3/8" of the top of the thermocouple (see illustration below).
If it does not, contact your dealer for service.
2 Shut off gas to the heater by turning the gas control knob to "OFF" (see step A under "Starting the Pilot" on page
21). Let the heater cool for 15 minutes. Open the door (see page 16).
3 Remove the log set and embers (see page 17 - NOTE: the log set is fragile). If any log is cracked or
deteriorated, replace it when re-installing. Check the logs for sooting. If excessive sooting is found, the heater
will require adjustment. Contact your dealer.
4 Clean the burner pan (especially the burner holes) and inspect the following:
• Check for burner for cracks, warps, or other damage.
• Check the firebox and area around the pilot to make sure there is no warping or damage.
If any problem is found, discontinue use and contact your dealer for service.
Before Disassembly -
Check the pilot flame. It
should touch the
thermocouple and
thermopile.
Thermopile
5 Replace the log set. Inspect the glass gasket. If it is deteriorated, replace. If the glass is damaged, replace it.
6 Check the gas control valve and all of the gas lines. If any damage is found, discontinue use and contact your
dealer for service.
7 To check the door seal, place a dollar bill along the door perimeter then close and latch the door. If the dollar bill
is held in place securely, the door seal is adequate. However, it the dollar bill slides out easily, you should adjust
the door. Contact your dealer to obtain directions on tightening the door seal.
8 Start the pilot and turn on the main burner. The flames should be orange/yellow and not touch the top of the
firebox. If the pilot or main burners do not burn correctly, contact your dealer for service. Monitor the blower
operation.
9 Remove any debris or vegetation near the vent termination. Contact your dealer if any sooting or deterioration is
found near the vent termination.
Travis Industries

Maintenance

Check the walls and ceiling of the firebox for
deterioration.
Pilot Hood
Check the
burner holes.
Thermocouple
9 3 5 0 8 1 2 1
Make sure the
burner is not
warped or
damaged.
2 3 1 0 0 0