Exmark Turf Tracer HP Operator's Manual page 37

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.2.2
NOTE: All (4) pins must equally support the weight of the deck.
Adjustment in the length of the rear deck support assemblies may be
necessary. If one side is longer than 6.89" (17.5 cm), than the opposite
side must be shorter by the same amount.
CUTTING HEIGHT ADJUSTMENT
ANTI-SCALP ROLLER BOLT INSTALLATION
ANTI-SCALP ROLLER AND CUTTING HEIGHT ADJUSTMENT
c) Adjust anti-scalp rollers For Normal Operating Conditions. Stop engine and
wait for all moving parts to stop. Place rollers in one of the positions shown
in Figure 10. Rollers will maintain 3/4 in. (1.9 cm) clearance to the ground
to minimize gouging and roller wear or damage. For Maximum Deck
Flotation, place rollers one hole position lower. Rollers should maintain 1/4
in. (.64 cm) minimum clearance to ground. Do Not adjust rollers to support
the deck. Be sure spring disc washer is installed with the cone towards the
nut. Tighten nuts properly.
d) When operating in extremely rough conditions it may be necessary to
position the anti-scalp rollers one or two holes higher than described in "c"
to prevent damage to the rollers and/or bolt failure (See Figure 10).
NOTE: When anti-scalp rollers are placed in these positions, reduced
deck flotation will result.
PTO Engagement Linkage: Located between the PTO engagement lever on the
left handle and the left rear corner of the engine deck.
a) Stop engine and wait for all moving parts to stop.
www.mymowerparts.com
FIGURE 9
FIGURE 10
- 32 -