Plumbing; Connection To The Water Inlet - Miele G 603 Installation Instructions Manual

Plumbing

Connection to the water inlet

,
Water in the dishwasher must
not be used as drinking water.
– The dishwasher may be connected
to a cold or hot water supply, max.
60 °C. When connected to a hot wa-
ter supply all programme stages
which would otherwise be carried out
with cold water (pre-wash and
interim rinse) as well as the Pre-wash
programme will be carried out with
hot water.
On models with recirculation
condensation drying please note that
if your dishwasher is connected to a
hot water supply drying results may
be impaired.
– The inlet hose is approx. 1.5 m long;
a longer hose (4 m), or a 1.5 m long
flexible metal hose tested to
withstand pressure of 140 bar may
be bought from the Miele Spare Parts
Dept.
– A stopcock with a 3/4 " male thread
must be provided on site.
– The dishwasher is constructed to
comply with DVGW regulations, and
may be connected to a suitable
supply without an extra non-return
valve if national regulations allow
this.
– The water pressure (flow pressure at
the take-off point) must be between
0.3 and 10 bar.
If the water pressure is too low the
Water "inlet" or "inlet / drain" light
(depending on model) may light up,
(see "Problem solving guide" in the
Operating Instruction booklet).
22
If the water pressure is too high, a
pressure reducer valve must be
fitted.
!
The inlet hose must not be
shortened or damaged in any way
as it contains electrical components
(see illustration).
If the stopcock is situated in the work-
top, a special angle connector can be
ordered from the Miele Spare Parts
Dept. (Part No. 04 274 820).