Fitting The Matching Door Front - Miele G 603 Installation Instructions Manual

Installation
3. Fitting the matching door
front
The front of the dishwasher needs to be
fitted with a base unit front to match the
kitchen furniture. This door front may be
a single panel or a two-piece panel,
divided to give a dummy drawer facia
line.
Dimensions:
Width:
to match the door of a 45 cm wide base
unit.
Total height:
Height of a full base unit front, or with a
two-piece panel, height of shorter unit
front plus gap plus dummy drawer
facia.
Thickness:
18 mm in the areas where the fixing
bracket is screwed on.
A fixing bracket must be fitted to the
rear of the door front panel. This is then
used for attaching the door front panel
to the door outer panel on the machine.
A door handle must be fitted to the front
of the door front before the fixing
bracket is fitted.
Position the door handle to match
others in the kitchen. It should be at
drawer height in the centre of the panel.
The door handle fixing screws must
be countersunk, to avoid any
protrusions at the rear of the door
front.
12
,
The weight of the door front will
affect the functioning of the door
springs. After fitting it is essential for
this to be checked out. See Step 6.
When the dishwasher is delivered the
fixing bracket is secured to the
dishwasher. To remove it:
^ Open the dishwasher door slightly.
^ Loosen the fixing screws (see thin
arrow) on each side of the machine
outer door panel.
^ Push the fixing bracket upwards off
the sprung bolts and remove.