Adjusting The Door Front - Miele G 603 Installation Instructions Manual

Installation

4. Adjusting the door front

When fitted the door front can be
adjusted up to a maximum of 2 mm
upwards or downwards to match
adjoining unit fronts.
^ Open the dishwasher door slightly.
^ With the door open, press the front
panel on one side against the door
outer panel.
^ Adjust the height of the door front on
this side using the lower recessed
adjusting screw (TORX T20).
higher = turn clockwise
lower = turn anti-clockwise
^ Then secure the door front on this
side by tightening the upper
recessed fixing screw (TORX T20) at
the side of the machine door outer
panel.
^ Repeat the process on the other side
of the door.
16
^ Close the dishwasher door.
^ Check the alignment of the door
panel again.
^ If it is not correctly aligned you may
need to loosen the screws and
re-adjust it to the correct alignment.
Once satisfied that the alignment is
correct:
^ Open the dishwasher door.
^ Tighten all fixing screws (upper
screws, TORX T20) at the sides.
^ Plug fixing screw and height
adjustment screw recesses with the
plastic stoppers supplied.