Table of Contents
Advertisement
4 COMMUNICATIONS
4.6 COMMUNICATION
4.6.3 UPGRADE FIRMWARE VERSION
IMPORTANT WARNING: For upgrading the relay firmware to version 4.00 or later, it is mandatory that the
ENERVISTA MII Setup version is 1.10 or higher. For firmware version 5.00 or later, the ENERVISTA MII Setup
version must be 2.10 or later. Otherwise it may result in damage to the relay
The UPGRADE FIRMWARE VERSION option is active only when there is no active communication with the relay. If the PC
is communicating with the relay, the user must switch communication off in Communication > Computer menu to activate
this option.
When this option is selected, a window appears asking for the new firmware version file to be uploaded to the relay:
4
Figure 4–26: FLASH UPDATE FILE
After selecting the file that will be used to update the FLASH memory, the following screen will be displayed:
Figure 4–27: RELAY IDENTIFICATION
After introducing the Slave Address and Relay password (1 and 1 by default), the following screen will be displayed,
showing details of the old model and the new model:
GEK-106237P
MIFII Digital Feeder Relay
4-21
Advertisement
Table of Contents
