Furuno NAVpilot-711C Installation Manual page 67

Trim gain
Note: [TRIM GAIN] is not shown in case of Fantum Feedback
The NAVpilot continually monitors the boat's trim in order to keep the trim sensitivity opti-
mum. A lower setting is common because boat's trim usually does not change quickly. A
large number changes the trim compensation value more frequently. Too high of a setting
may result in the following problems.
• Trim sensitivity is over-affected, resulting that a trim appears in both port and starboard
directions alternately.
• Trim compensation mechanism responds to the yawing, resulting in more serious oscil-
lation of ship's heading.
To automatically set the trim, do as follows:
1. Rotate the knob to select [TRIM GAIN] from the [PARAMETER SETUP] menu.
2. Push the knob to show the options for [TRIM GAIN].
3. Rotate the knob to select [AUTO] or [MANUAL] then push the knob. For [AUTO] go to
step 4. For [MANUAL] do as follows:
1) Rotate the knob to select the current value and push the knob.
2) Rotate the knob to set a value (1 to 20, the default value is automatically calculated
according to length of your boat, entered on the [SHIP'S CHARACTERISTICS]
menu.
4. Push the knob to finish.
Speed calculation
Speed is normally entered automatically, from your navigator. If the navigator fails, man-
ually enter speed.
1. Rotate the knob to select [SPEED CALCULATION] from the [PARAMETER SETUP]
menu.
2. Push the knob to the options for [SPEED CALCULATION].
3. Rotate the knob to select [AUTO] or [MANUAL] then push the knob. For [AUTO] go to
step 4. For [MANUAL], do as follows:
1) Rotate the knob to select the current value and push the knob.
2) Rotate the knob to set a value (0.1 - 99.0).
4. Push the knob to finish.
AUTO
MANUAL
AUTO
MANUAL
3. INITIAL SETTINGS
TM
.
3-31