Skoda Octavia Owner's Manual page 99

98 Heating and air conditioning system
Overview of the control elements
The controls enable a separate setting of the temperature for the
left and right side.
Fig. 108 Climatronic: Control elements
The buttons
A Defrost windscreen intensively
1
A Air flow to the windows
2 
A Air flow to head
3 
A
Air flow in the footwell
4 
A
Recirculated air mode with air quality sensor
5 
A
Rear window heater
6 
Buttons/control dial
A Setting of the temperature for the left side, operation of the seat heating of the
7
left front seat
A
Automatic mode
AUTO
8
A Switching off Climatronic
OFF
9
A Setting the blower speed
10 
A Button for direct switching on/off of auxiliary heating (auxiliary heating)
11
 page 100
A Switching on/off of the temperature setting in dual mode
12
A Switching cooling on and off
13
A Setting of the temperature for the right side, operation of the seat heating of
14
the right front seat

DUAL
AC
Note
Below the top row of buttons is located the interior temperature sensor. Do not
glue or cover over the sensor, otherwise it could have an unfavourable effect on the
Climatronic.
Automatic mode
The automatic mode is used in order to maintain a constant temper-
ature and to demist the windows in the interior of the car.
Switching automatic mode on
– Set a temperature between +18 °C and +26 °C.
– Move the air outlet vents 3 and 4
directed slightly upwards.
– Press the button
AUTO
depending on which unit was last selected.
If the warning light in the top right corner of the button
Climatronic operates in "HIGH" mode. The "HIGH" mode is the standard setting of
the Climatronic.
When pressing again the button
mode and the warning light in the top left corner lights up. The Climatronic uses only
in this mode the lower blower speed. However taking into account the noise level,
this is more comfortable, yet be aware that the effectiveness of the air conditioning
system is reduced particularly if the vehicle is fully occupied.
By pressing again the button
The automatic mode is switched off by pressing the button for the air distribution
or increasing or decreasing the blower speed. The temperature is nevertheless
regulated.
switching cooling on and off
switching cooling on and off

– Press the button  fig.
AC
– When you again press the switch
warning light in the button goes out. Only the function of the ventilation
remains active when no lower temperature than the outside temperature can
be reached.
 page 91, fig. 104, so that the air flow is
. In the right or left top corner a warning light lights up,
AUTO
AUTO , the Climatronic changes into the "LOW"
, you change into the "HIGH" mode.
AUTO
108. The warning light lights up in the button.
, the cooling system is switched off. The
AC
lights up, the