Skoda Octavia Owner's Manual page 224

Front parking lights and low beam
Removing the light bulb for the parking light
– Switch the ignition and all lights off.
Remove the headlight  page 222.
–
– Remove the protective cap
A  fig.
– Remove the socket
A
– Take the faulty bulb out of the fixture and insert a new one.
– Insert the protective cap.
Removing the light bulb for the low beam light
– Switch the ignition and all lights off.
Remove the headlight  page 222.
–
– Remove the protective cap
– Turn the connector with the light bulb
 fig.
remove 195.
– Replace the lamp, insert the connector with the new lamp and turn to the right
up to the stop.
– Insert the protective cap.
Note
•
In order to facilitate the removal of the socket with the bulb for the parking light,
we recommend to remove first of all the bulb for the low beam light.
Using the system Safety
Fig. 195 Removing the bulbs for the
parking and low beam light
A  page 221, fig.
192.
B
195.
A  page 221, fig.
192.
B
A
up to the stop towards the left and
B
Driving Tips
•
After installing the headlight, the headlight setting must be checked by a
specialist garage.
Main beam
– Switch the ignition and all lights off.
Remove the headlight  page 222.
–
A
– Remove the protective cap
C
A  fig.
– Unplug plug 196.
A
A
– Press the wire clamps in the direction of the headlight and then unhook
B
them to the side.
A
– Remove the light bulb and insert the new light bulb in such a way that the
C
fixing lugs of the light bulb socket fit into the recesses at the reflector.
Installation takes place in the reverse order.
Note
After installing the headlight, the headlight setting must be checked by a specialist
garage.
General Maintenance Breakdown assistance
Fuses and light bulbs
Fig. 196 Removing the light bulb for the
main beam light
 page 221, fig.
192.
Technical data
223