Inspection; Ignition System Peak Voltage - Suzuki RM250 Owner's Service Manual

INSPECTION

IGNITION SYSTEM PEAK VOLTAGE

• Remove the seat and fuel tank. (5-4)
• Remove the spark plug.
• Disconnect the magneto lead wire coupler 1.
Measure the ignition system peak voltage in the following proce-
dure:
• Connect the multi-circuit tester with the peak volt adaptor as
follows. (See table below.)
• Measure the highest peak voltage by depressing the kick
starter lever several times forcefully.
+ Black/Red – - Red/White
Exciter
+ Red – - Green
Pick-up
+ Yellow – - Black/White
Charge
 Tester knob indication: Voltage ()
 09900-25008: Multi-circuit tester
• Connect the magneto lead wire coupler and disconnect the
ignition coil lead wire coupler 2.
25 V and more
2 V and more
8 V and more
ELECTRICAL SYSTEM 13-7
B/R
Y
R/W
G
B/W R