Panasonic TU-Z100U Service Manual page 37

8.2.26. Remove the C3-Board
1. Unlock the cable clampers to free the cable.
2. Remove the DD-Heat-sink fastening screws (×10
3. Remove the DD-Heat-sink (×5).
4. Disconnect the flexible cables (CB11, CB12, CB13, CB14
and CB15).
5. Disconnect the flexible cable (C36).
6. Disconnect the connectors (C33 and C35).
7. Remove the screws (×4
8.2.27. Remove the Barrier
1. Remove the Print Circuit Board.
2. Remove the Barriers.
).
) and remove the C3-Board.
8.2.28. Remove the Control button
1. Disconnect the flexible cable (J1). (See section 8.2.17.)
2. Remove the screws (×11
3. Remove the Cabinet bottom.
4. Remove the Control button.
8.2.29. Remove the Corner metal
1. Remove the screws (×3
2. Remove the Corner metal (LT, RT).
3. Remove the screws (×3
(×1 each).
4. Remove the Corner metal (LB, RB).
8.2.30. Remove the Cabinet assy from the
Plasma panel.
1. Place the Cabinet assy on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
37
).
each).
each) and remove the screw