Panasonic TU-Z100U Service Manual page 32

8.2.8. Remove the AC inlet assy
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Remove the screws (×2
assy.
8.2.9. Remove the P-Board
CAUTION :
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (P51-P57, P52-P58, P53-P54
and P55-P56).
3. Disconnect the connectors (P2, P6, P7, P11, P12, P34
and P35).
4. Remove the screws (×6
Board.
5. Remove the screws (×6
Board.
) and remove the AC inlet
) and remove the P(SUS)-
) and remove the P(MULTI)-
6. Remove the Partition P-Board.
7. Disconnect the connector (P9).
8. Remove the screws (×6
Board.
32
) and remove the P(FILTER)-