Sending Discrete Power O N And Off - Dish Network Satellite Receiver User Manual

Chapter 9 381.fm Page 58 Thursday, May 21, 2009 6:13 PM
Chapter 9
Sending Discrete Power On and Off
S D
ENDING
Installers use Remote control discrete power ON and power OFF IR commands when
programming macro commands into universal remotes. Using an ON-only or OFF-only command
is more effective than a toggle ON/OFF command when trying to make sure the satellite receiver is
reliably in one state or the other. To use discrete power commands, complete the following:
T
IPS
• If you don't want to accidentally change channels on your TV or VCR, try programming the
remote control in Limited Mode as described on page 49.
• Be sure to put the remote control back in SAT mode whenever you're finished watching TV.
Q
UESTIONS
• My remote doesn't control my receiver or other components. What should I do?
– Put the remote control is in the correct mode (page 49).
– Check the remote control address (pages 47 and 53).
– Check the batteries (page 8).
58
P O
ISCRETE OWER
O
N AND FF