Elapsed Recording Time - JVC HM-DR10000EU Instructions Manual

1 – –:– –
2
1 2 3
4 5 6
7 8 9
0
0000
1
2

Elapsed Recording Time

Indication
You can check the exact time of a recording.
1
2
Tape Remaining Time
– –:– –
1
3
4
4
3
NOTE:
Depending on the type of tape used, there may be times when
the tape remaining time reading may not appear right away, or
is not correct. "– –:– –" may sometimes appear, or the display
may blink on occasion.
SET COUNTER DISPLAY
Press – –:– – (or DISPLAY) until a counter reading
appears on the display panel.
RESET COUNTER
Press 0000 (or COUNTER RESET) before starting
recording or playback.
The counter is reset to "0:00:00" and shows the exact
elapsed time as the tape runs.
DISPLAY REMAINING TIME
Press – –:– – (or DISPLAY) until the time remaining on
the tape appears.
The display panel shows the tape remaining time
with " " displayed.
By pressing the – –:– – (or DISPLAY) button, you can
change the display to show the counter reading,
channel position*, clock time or tape remaining time.
* channel position is not displayed during playback.
25
EN