JVC HM-DR10000EU Instructions Manual page 35

1 – –:– –
2
1 2 3
4 5 6
3
4
7 8 9
4
0
3
1
2
Auto SP LP Timer
(S-VHS/VHS Mode Only)
If, when timer-recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-
minute tape
Approximately 150 minutes
Make sure you set "AUTO SP LP TIMER" to "ON" at the Mode
Set screen before the timer-recording starts.
MENU
OK 1
2
3
4
NOTES:
If you have programmed the recorder to timer-record 2 or
more programmes, the second programme and those
thereafter may not fit on the tape if you set "AUTO SP LP
TIMER" to "ON". In this case, make sure the mode is not
engaged, then set the tape speed manually during timer
programming.
In order to ensure that the recording fits on the tape, this
feature may leave a slight non-recorded section at the end of
the tape.
There may be some noise and sound disturbance at the point
on the tape where the recorder switches from SP to LP mode.
The Auto SP LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 or with some tapes
of shorter lengths.
If you perform timer recording with both VPS/PDC and the
Auto SP LP Timer activated, and the programme goes
beyond its originally scheduled length, there may be times
when the programme cannot be recorded in its entirety.
SP mode
Total 210 minutes
ACCESS MAIN MENU SCREEN
Press MENU.
ACCESS MODE SET SCREEN
Press %fi to move the highlight bar (pointer) to "MODE
#
SET", then press OK or .
SELECT MODE
Press %fi to move the
highlight bar (pointer) to
"AUTO SP LP TIMER",
#
then press OK or to select
"ON".
RETURN TO NORMAL SCREEN
Press MENU.
35
EN
Approximately 60 minutes
LP mode
MODE SET
B. E. S. T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O. S. D. ON
DIRECT REC ON
AUTO SP=LP TIMER ON
DIGITAL 3R ON
NEXT PAGE
[5∞] =
[MENU] : EXIT