Installation Place - Toshiba RAS-10G2KVP-E Service Manual

10-3. Indoor Unit

10-3-1. Installation Place

• A place which provides the spaces around the
indoor unit as shown in the diagram.
• A place where there are no obstacle near the air
inlet and outlet.
• A place which allows easy installation of the piping
to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed as top of the
indoor unit comes to at least 2 m height.
Also, it must be avoided to put anything on the top
of the indoor unit.
CAUTION
• Direct sunlight on the indoor unit wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to RF noise sources.
(For details, see the owner's manual.)
Remote control
• A place where here are no obstacles such as a
curtain that may block the signal from the indoor unit
• Do not install the remote control in a place exposed
to direct sunlight or close to a heating source such
as a stove.
• Keep the remote control at least 1 m apart from
the nearest TV set or stereo equipment.
(This is necessary to prevent image disturbances or
noise interference.)
• The location of the remote control should be
determined as shown below.
(Side view)
Remote
Reception
control
range
Fig. 10-3-1
(Top view)
Indoor unit
Remote
control
10-3-2. Cutting a Hole and Mounting
Installation Plate
Cutting a hole
When installing the refrigerant pipes from the rear.
The center of the pipe hole
is above the arrow.
1. After determining the pipe hole position on the
installation plate (
mm) at a slight downward slant to the outdoor
side.
NOTE :
• When drilling into a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
Mounting the installation plate
Anchor bolt holes
190
104
Hook
Pipe hole
Indoor unit
– –
66
FILE NO. SVM-14017
35
Fig. 10-3-2
ð
) drill the pipe hole (Ø65
Hook
Hook
Pipe hole
Thread
5
Mounting screw
Weight
Fig. 10-3-3
52
40
225
137
1
Installation
plate