Keypad And Display; Operation Startup - DeVilbiss SleepCube DV53 Standard Plus CPAP User Manual

Sleepcube positive airway pressure device
Hide thumbs Also See for SleepCube DV53 Standard Plus CPAP:
Table of Contents

Advertisement

Available languages

Available languages

kEypaD anD DiSplay/

opEration
KeyPaD anD DisPlay
BasicDeVilbissSleepCubeControls
Name
Symbol Function
ON/OFF
HEATER
DELAY

NOTe–
T he additional control buttons that you see on the SleepCube control panel provide
advanced controls for specific settings. Please refer to the 'Advanced Menu Controls'
section on page 13 for more details.
oPeRaTion
Startup
To begin operation, verify that your SleepCube is connected to a
'live' power source. When plugged in, the LCD display should
appear as noted.
Put on your CPAP mask and press the ON/OFF button on the keypad to turn on airflow OR
put on your CPAP mask and take a few breaths to turn on airflow automatically. The
pressure in your mask will rise to the set pressure in about 10 seconds.
NOTe– If the device does not automatically start after taking 2-3 breaths, this feature may have
been disabled. If Auto ON/OFF is disabled, you must manually press the ON/OFF
button to start and stop the device.
The keypad display shows the actual mask pressure while the
device is in use. Because this is the actual pressure, the device
pressure reading may vary slightly as you breathe. Your display
should appear as noted.
If your DeVilbiss SleepCube system includes a humidifier, its
heater controls and status are displayed as noted in the image.

NOTe–
I f the display on your device is not similar to those listed above, refer
to the chapter section titled "Patient Messages" on page 21.
The ON/OFF button starts and stops the flow of air from the
device.
If your SleepCube has a heater/ humidifier attached, these
buttons adjust the heater setting. Increase the setting for more
humidity and decrease the setting for less humidity.
The Delay button activates the comfort delay feature and only
functions if this feature has been enabled. To understand how to
set the parameters of this feature, please refer to the Using the
Comfort Delay Feature found on page 12.
EN
OFF
P:10.0
CPAP
P:10.0
CPAP
Heat:Off
SE-DV53-1
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sleepcube dv54 autoadjust

Table of Contents