Connecting TagmaStore AMS and TagmaStore WMS subsystems
System parameters for connecting TagmaStore AMS and TagmaStore WMS
subsystems
Table 17
explains whether to specify system parameters when making settings for ports on TagmaStore
AMS and TagmaStore WMS subsystems.
Table 17
System parameter settings (TagmaStore AMS and TagmaStore WMS subsystems)
Pane name
Boot Options
System Parameter
Port Options
Host Connection
Mode
NOTE:
You can either specify or omit any other parameters.
Parameters
Start Attribute
•
Single Mode
•
Dual Active Mode
Delay Planned Shutdown
Drive blocking mode
Vendor ID
Product ID
ROM Microprogram Version
RAM Microprogram Version
Option
Operation if the processor failure occurs
WEB Title
Write and verify mode
Port Option
Host Connection Mode 1
Host Connection Mode 2
Parameter setting
Specify this parameter when the
TagmaStore AMS or TagmaStore WMS
subsystem is in the one-controller
configuration.
Specify this parameter when the
TagmaStore AMS or TagmaStore WMS
subsystem is in the two-controller
configuration.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
Keep this parameter as HITACHI (default),
and do not change.
Keep this parameter as DF600F (default),
and do not change.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
Set this parameter to Reset of occurred.
You can either specify this parameter or
omit specifying this parameter.
Set this parameter to ON.
You can either specify this parameter or
omit specifying this parameter.
Set this parameter to Standard Mode.
Do not specify any parameters.
NOTE:
Do not specify HISUP OFF mode,
either.
External Storage XP user guide 117