Operating Instructions; Glass Information; Louvre Removal; Window Frame Assembly Removal - Majestic 360DVS2 Installation Instructions & Homeowner's Manual

360 dvs series direct vent fireplaces
Table of Contents

Advertisement

Glass Information

Only glass approved by CFM Specialty
Home Products should be used on this
fireplace.
The use of any non-approved replacement glass will
void all product warranties.
Care must be taken to avoid breakage of the glass.
Do not operate appliance with glass front
removed, cracked or broken.
Replacement glass (complete with gasket) is
available through your Vermont Castings,
Majestic Products dealer and should only be
installed by a licensed qualified service person.

Louvre Removal

The top side and top end louvres are removed by
simply lifting the louvre assembly and pulling the
assembly away from the fireplace. (Fig. 36)
The lower side louvres are hinged along there lower
edge and are folded down for access to components
in the base cavity of the fireplace.
The lower end louvre assembly on the 360DVS3/
SL/ SR units is removed in the same manner as the
top louvre assemblies.
2.
1.
FP1227
Fig. 36 Remove louvre assembly top.

Window Frame Assembly Removal

Side Window Frame Assemblies
1. Shut off the gas supply.
2. Allow the fireplace to cool if it has been in operation.
3. Remove the top louvre assembly.
4. Lower the bottom louvre assembly.
5. Release the two clamps along lower edge of the
frame by pulling down on clamp handles. (Fig. 37)
10006326

Operating Instructions

Louvre
Glass Panel
360DVS Series Direct Vent Fireplaces
6. Tilt lower edge of frame out slightly and lift window
frame assembly up and away from the fireplace.
7. To reinstall the window frame assembly reverse
this procedure.
Front Window Frame Assembly
1. Remove the top and bottom louvre assembly.
2. Remove the lower window trim (held in place with
magnets).
3. Remove both lower retaining screws. Access to
these screws is gained through the holes along the
lower edge of the frame behind the trim. (Fig. 38)
4. Tilt lower edge of frame out slightly and lift window
frame assembly up and away from the fireplace.
5. To reinstall the window frame assembly reverse
the process.
Window
Frame
Assembly
Fig. 37 Window frame assembly removal.
Location of Lower
Retaining Screws
Fig. 38 Retaining screw.
Lower Clamps
Window
Frame
Assembly
Pull Clamp
Push
Hook
Clamp
Handle
FP1228
FP1445
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents