Adding A Binding Margin - Konica Minolta Bizhub C451 Operation Manual

Printing a user box document

Adding a binding margin

A binding margin can be added to the left or right side or to the top of the printed pages. Settings can be
specified for the following.
Parameter
Margin Position
Adjust Value
Image Shift
1
In the Print screen, touch [Page Margin].
2
Touch [Yes].
3
Select the desired position for the binding margin, and then use the keypad to specify the width of the
binding margin.
– The width of the binding margin can be specified in 0.1 mm increments.
– To set the binding margin to 0 mm, touch [None].
bizhub C650/C550/C451 (FE3)
Description
Select the location where the binding margin is to be added. If "Auto" is selected, a
binding margin along the long side of the paper is selected if the document length is
less than 297 mm. If the document length is more than 297 mm, a binding margin
along the short side of the paper is selected.
An area with a width between 0.1 mm and 20 mm can be specified. To specify a
binding margin of 0 mm, touch [None].
When a binding margin is created, the image can be shifted according to the position
of the created binding margin. The image can be shifted between 0.1 mm and 250
mm left, right, up or down, depending on the position of the binding margin. If the
document is to be printed double-sided, touch [Change Back Shift] to also specify
the shift on the back side of the pages.
5
5-13