Dspf Resist Roller Brake Clutch; Dspf Resist Roller Clutch; Torque Limiter - Sharp MX-M550U Service Manual

c. DSPF resist roller brake clutch
d. DSPF resist roller clutch
1) Remove the rear cover. (See "A-(1)-a. Cabinet")
2) Disconnect the connector, and remove the clamp, the plastic
Ering, the DSPF resist roller brake clutch (A), and the DSPF
resist roller clutch (B).
e. No.1 resist roller (Drive)
f. Torque limiter
1) Remove the cabinet. (See "A-(1)-a. Cabinet")
2) Remove the document feed tray unit.
(See "C-(1) Paper feed unit")
3) Remove the plastic E-ring in the arrow direction and remove
the No. 1 resist roller idle.
4) Remove the separation roller. (See "C-(2)-a. Separation
roller")
5) Remove the paper feed paper guide lower unit in the arrow
direction.
B
A
MX-M700N DSPF SECTION C – 12
6) Remove the bearing reception fixture, and remove the torque
limiter.
7) Remove the electromagnetic clutch.
(See "C-(2)-c. DSPF resist roller brake clutch")
8) Remove the resin E-ring, and remove the bearing.
9) Slide the No. 1 resist roller drive in the arrow direction, and
remove the plastic E-ring.
10) Remove No. 1 resist roller (Drive) in the arrow direction.